Plan ahead High security · Markham
High Security Locks
You jiggle the key a little and the old deadbolt opens even when the cut does not look quite right. If your worn key can do that, you wonder what a stranger with the right tools could do.
Call now · open 24/7(289) 306-0409In plain words
A high security cylinder is rated by independent laboratory testing that times how long it holds out against picking, impressioning, drilling, prying and wrenching. The lock body and deadbolt carry a separate hardware grade for strength, cycle life and finish. A locksmith reads those ratings for you and matches them to your door, because a rating on the box means nothing if the door frame is thin or the bolt barely enters the jamb. The visit usually ends with a heavier deadbolt, a reinforced strike fastened into the framing and a cylinder whose keys cannot be copied at a kiosk.
How the visit goesAfter the attempted break-in the police officer pointed at your door and said the strike plate was held by two short screws. Nobody got in, but you have looked at that door differently every evening since.
High Security Locks · Markham
How the visit goes
- 1
What the door is protecting
The assessment starts with a question rather than a tape measure: what is behind this door, and what has made you think about it now? A front door on a family home, a stockroom with prescription drugs and a server closet in an office carry different risks and deserve different levels of hardware. The locksmith also asks who has keys today and how sure you are of that count. Those answers decide whether the right answer is a graded deadbolt with a controlled key, a laboratory-rated cylinder in a heavy lock body, or a small keyed system across several doors. Spending goes where the risk actually sits.
- 2
Fitting a heavier deadbolt
When the existing deadbolt is light or worn, the locksmith fits a graded deadbolt through the same bore where possible. The bolt throws a full inch and carries a hardened steel pin that turns under a saw blade, and the housing keeps part of the bolt supported against a kick. The latch is set in the edge bore with the correct backset, the exterior housing and interior thumb-turn are joined through the door with the long screws, and the final tightening is done by hand so nothing strips. The bolt is then thrown with the door open and closed to confirm it extends completely.
- 3
A door that shuts like a vault door, quietly
With a heavy bolt, a deep strike and long screws in the frame, the door feels different when you lock it: the bolt travels its full length and seats with a solid, quiet stop. That feel is your ongoing check. If the bolt ever starts to drag or you need to lift the door to lock it, the door or hinges have moved with the seasons and a small adjustment restores it. Wood doors swell in humid summers and shrink in dry winters; a glance at the hinge screws and the strike each spring and autumn keeps everything aligned.
In the van
- Code key cutting machine
- High-security cylinder
- Key control authorisation card
- Box strike
- Graded deadbolt with hardened bolt
What affects the quote
- 1
Master keying
Arranging staff keys, area keys and a manager key on one system takes bench time to plan and pin, and the more levels you want, the more careful that planning is.
- 2
Distance and access
A rural property, a high-rise with loading dock rules or a site that must be visited outside trading hours affects travel and scheduling, and the quote says so plainly.
- 3
Mortise and older doors
An existing mortise pocket, a thick slab door or an unusual backset can mean a specific cylinder or an adapted preparation, which takes longer than a standard bore.
Same fees day, night or weekend.
High Security Locks: questions
Do high security locks need special maintenance?
Only light care. Use the dry lubricant the locksmith recommends once or twice a year, never oil, which gathers grit around the finger pins and sidebar. Keep the keyway free of debris and insert the key fully before turning. In winter, warm a resisting key in your hand or use a de-icer rather than forcing it. Check hinge and strike screws each season so the door stays aligned. Treated this way the cylinder lasts for decades.
What should I do when a controlled key is lost?
Tell your locksmith so the register is updated, then decide together what the loss means. If the key was lost with nothing identifying your address, the practical risk is low and many people simply strike it off. If it went missing with identification or from a known person, the affected cylinders can be repinned so that key stops working while the rest of the system continues. Because the keyway is controlled, you know that no further copies exist.
Are high security locks only for businesses?
Not at all. Homes are the most common place they are fitted, especially after a move, a break-in nearby, or the realisation that too many keys have been handed out over the years. A graded deadbolt with a patented cylinder and a reinforced strike is a modest, quiet upgrade for a front or side door. Businesses tend to go further, with laboratory-rated cylinders, heavy lock bodies and a documented key system across many doors.
High Security Locks
High Security Locks near you
York, Ontario
Markham information
- Town
- Markham, York, Ontario
- In business
- 33 years
- Hours
- Open 24/7 · nights, weekends and holidays, same fees
- Phone
- (289) 306-0409
- Visits
- On-site assessment preferred. Request a visit or call.
What the census means at the door
19%
Newer homes. About 19% of homes in Markham were built in 1980 or earlier, according to the 2021 Census.
Recent builds often have steel or fibreglass entry doors rather than solid wood. They resist warping and take hardware well, and a locksmith fitting a deadbolt or reinforced strike works with the door's construction so screws bite into something solid.
56%
A mix of homes. Single-detached houses make up about 56% of homes in Markham (2021 Census).
Where housing types are mixed, the same lost-key call means different things. In a house, rekey every door on the property. In an apartment, rekey the suite door and check with management about the common entrance. The locksmith asks which it is first.
Open 24/7
Request a visit
You jiggle the key a little and the old deadbolt opens even when the cut does not look quite right.
Call now · open 24/7(289) 306-0409- On-site assessment preferred
- Same fees day, night or weekend
- 33 years in business